beautypg.com

Rill, Ssembly installing char-master briquets – Broilmaster T3N-1 T3C-1 User Manual

Page 11

background image

Page 11

B101051-0-1106

9. Remove ignitor button and insert AA battery, positive

side down, and replace ignitor button. See Figure 10.

10. Install foam grip (4) on lid handle (3). See Figure 11.

Tip: For ease of installation, slightly lubricate the lid

handle with liquid soap before pushing the foam grip

into place.

11. Fasten the lid handle to the grill body top (1) with two

#10-24 x 1" screws. See Figure 12.

12. Place the briquet rack (7) or flavor screen (9) over the

burners. See Figure 13.

13. T3 and T3C models only: Position the Char-Master bri-

quets evenly on the briquette rack without overlapping.

See Figure 13.

14. Set the cooking grids (6). See Figure 13.

15. Push valve knobs (22) on to valves.

Figure 10

Figure 11

Figure 12

G

RILL

A

SSEMBLY

Installing Char-Master Briquets

Individually place the ‘Char-Master’ briquets in a single layer

evenly on your grill’s briquet rack; DO NOT dump them onto

the briquet rack. A single layer of ‘Char-Master’ briquets is

all that’s needed. DO NOT overlap or stack the briquets.

See Figure 13.

After properly placing the ‘Char-Master’ briquets on your

grill’s briquet rack, there may be some briquets left over.

Save them for future use.

Before cooking, always preheat the grill as directed by the

grill’s operating instructions. Hot briquets cause better,

quicker cooking and better flavor.

Cleaning

Routine preheating and routine burn-off (also called post

heating) of a grill will clean the ‘Char-Master’ briquets. Pe-

riodically turn the briquets over while they are cool.

Figure 13

T3 & T3C MODELS

T3CF MODELS

This manual is related to the following products: