Baracoda BLUETOOTH RS232RS232 - Manual (Page 12)

Baracoda RS232 dongle Plug & Scan – User Guide v3.28.2 - 12 -
Data Capture
for Workforce
in Motion
How to connect your RoadRunners/RoadRunners How to connect your RoadRunners/RoadRunners How to connect your RoadRunners/RoadRunners How to connect your RoadRunners/RoadRunners
Evolution Evolution Evolution Evolution
1. Reset the scanner (see RoadRunners User Guide to perform this operation).
2. Plug the dongle into the RS232 COM port of the computer and switch it on.
3. Do not scan any other barcodes except the ‘connect barcode’ that is delivered with the dongle.
4. Within 5 seconds (not necessary to rescan), the connection is established. The scanner beeps twice
and right LED will change to a double flashing green.
5. Open up the target application (such as Notepad, Excel and Word). Make sure the application can
accept data from a keyboard and the active cursor is where you want the barcode information to be
placed.
6. Start scanning barcodes.
By default, the Plug & Scan dongle activates the “No Data Loss Mode”. (Please refer to the paragraph 2.3
for additional information)
How to connect your ScanWear How to connect your ScanWear How to connect your ScanWear How to connect your ScanWear
1. Reset the scanner (see ScanWear User Guide to perform this operation).
2. Plug the dongle into the RS232 COM port of the computer and switch it on.
3. Do not scan any other barcodes except the ‘connect barcode’ that is delivered with the dongle.
4. Within 5 seconds (not necessary to rescan), the connection is established. The scanner beeps twice
and the right LED will change to a double flashing green.
5. Start scanning barcodes.
By default, the Plug & Scan dongle activates the “No Data Loss Mode”. (Please refer to the paragraph 2.3
for additional information)
How to connect your ToughRunners How to connect your ToughRunners How to connect your ToughRunners How to connect your ToughRunners
1. Reset the scanner (see ToughRunners User Guide to perform this operation).
2. Plug the dongle into the RS232 COM port of the computer and switch it on.
3. Do not scan any other barcodes except the ‘connect barcode’ that is delivered with the dongle.
4. Within 5 seconds (not necessary to rescan), the connection is established. The scanner beeps twice
and the LED will change to a double flashing blue.
5. Start scanning barcodes.
By default, the Plug & Scan dongle activates the “No Data Loss Mode”. (Please refer to the paragraph 2.3
for additional information)