Cub Cadet 930 SWE - Manual (Page 11)

Throttle Control
The throttle control is located on the rear
of the engine. It regulates the speed of the
engine and will shut off the engine when
moved into the STOP position.
Primer Bulb
Pressing the primer bulb forces fuel directly
into the engine’s carburetor to aid in starting
a “Cold” engine. NOTE: Do not use the
primer bulb to restart a warm engine after a
short shutdown.
Oil Fill
Engine oil level can be checked and oil
added through the oil fill.
Skid Shoes
Position the skid shoes based on surface conditions. Adjust
upward for hard-packed snow. Adjust downward when
operating on gravel or crushed rock surfaces.
Electric Starter Outlet
Requires the use of a three-prong outdoor extension cord
and a 120V power source/wall outlet.
Recoil Starter Handle
This handle is used to manually start the engine.
Electric Starter Switch
Pressing the button on the top of the electric starter switch
engages the engine’s electric starter when plugged into a
120V power source.
Augers
When engaged, the augers rotate and draw snow into the
auger housing.
Chute Assembly
Snow drawn into the auger housing is discharged out the
chute assembly.
Gas Cap
Unthread the gas cap to add gasoline to the fuel tank.
Auger Control
The auger control is located on the left handle. Squeeze
the control grip against the handle to engage the augers
and start snow throwing action. Release to stop.
Drive Control / Auger Clutch Lock
The drive control is located on the right handle. Squeeze
the control grip against the handle to engage the wheel
drive. Release the handle to stop.
The drive control also locks the auger control so that
you can operate the chute directional control without
interrupting the snow throwing process. If the auger
control is engaged simultaneously with the drive control,
the operator can release the auger control (on the left
handle) and the augers will remain engaged. Release both
controls to stop the augers and wheel drive.
Note: Always release the drive control before changing
speeds. Failure to do so will result in increased wear on
your machine’s drive system.
11 s
ectiOn
4 — c
OntrOls and
f
eatures