B&C Speakers 15 TBX 40 - Manual

Speakers
HPL
Coaxials HF Compression drivers Horns
Specifications
Nominal Diameter 380 mm (15 in)
Nominal Impedance 8 Ω
Minumum Impedance 6.1 Ω
Power Handling
(40 –400 Hz)
Nominal
1 1000 W
Continuous Program 2 2000 W
Sensitivity (1W/1m) 3 97 dB
Frequency Range 35 -1800 Hz
Voice Coil Diameter 100 mm (4 in)
Winding Material Copper
Former Material Glass Fibre
Winding Depth 25 mm (1 in)
Magnetic Gap Depth 12 mm (.47 in)
Flux Density 1.1 T
Also available in 4 Ω, data upon request
Thiele & Small Parameters 4
Fs 38 Hz
Re 5.2 Ω
Qes 0.29
Qms 6.3
Qts 0.28
Vas 131 dm 3 (4.6 ft 3 )
Sd 855 cm 2 (132.5 in 2 )
η
0 2.3 %
X max ± 9 mm
X Var ± 11 mm
Mms 141 g
Bl 24.6 T·m
Le 1.8 mH
Mounting and Shipping Information
Overall Diameter 394 mm (15.5 in)
Bolt Circle Diameter 374 mm (14.6 in)
Baffle Cutout Diameter 355 mm (13.9 in)
Depth 158 mm (6.2 in)
Flange and Gasket Thickness 16 mm (0.63 in)
Net weight 10.2 kg (22.4 lb)
Shipping Weight 11.5 kg (25.3 lb)
Shipping Box 450x450x200 mm
(17.7x17.7x8 in)
1 2 hours test made with continuous pink noise signal (6 dB crest factor) within the
specified range. Power calculated on rated minimum impedance. Loudspeaker in
free air.
2 Power on Continuous Program is defined as 3 dB greater than the Nominal rating.
3 Applied RMS Voltage is set to 2.83V for 8 ohms Nominal Impedance. Average SPL
from 200 to 1200Hz.
4 Thiele-Small parameters are measured after a high level 20 Hz sine wave precon-
ditioning test.
15 TBX 40 |
Woofer
2000 W power handling, 4" voice coil with very high thermal
capability and a ventilated magnet assembly that allows a low power
compression. A very low distortion figure is obtained using a double
spider design and dual demodulation rings in the magnetic path.
Proprietary water-proof cone treatment for safe use in adverse
climatic conditions. State of the art performance, in the smallest
possible enclosure, set the 15 TBX 40 as a benchmark loudspeaker.