Philips Kabelloses Dampfbügeleisen - Manual (Page 11)

C
2 Take the iron from the stand.
3 HI575 only: put the iron back on the stand when the
temperature light starts blinking.This indicates that the iron
has cooled down below the set temperature.
◗ When you stop ironing for a while, always put the iron on the
stand to allow it to heat up again.
◗ When you use the shot-of-steam or turbo-steam function, the
iron may cool down rather quickly.We advise you to iron in
corded mode when using these functions.
Steam ironing
1 Make sure that there is enough water in the water tank.
2 Select the recommended ironing temperature (see section
'Setting the temperature').
3 Put the iron on the stand.
C
4 Put the mains plug in the wall socket.
The iron starts heating up.
◗ As soon as the water in the water tank is hot enough for steam
ironing, the temperature light goes out.
C
5 Set the steam control to the required position to start steam
ironing.
◗ Steam ironing is only possible at higher ironing temperatures
(temperature settings 2 to MAX).
◗ Select the recommended steam setting:
B 1 - 2 for moderate steam (temperature settings 2)
B 3 - 6 for maximum steam (temperature settings 3 to MAX)
◗ During steam ironing the temperature light goes on from time to
time.This indicates that the iron is heating up to the set
temperature.
Ironing without steam
◗ To iron without steam, proceed as described for steam ironing but
set the steam control to position 0 (no steam).
1 Select the recommended ironing temperature (see section
'Setting the temperature').
ENGLISH 11
LINEN HILO
SILK SEDA
NYLO N NILO N
WOOL LANA
COTT ON ALGO DON
M A X M IN