Liebherr WTr 4211 Vinothek User Manual
Page 9
17
GB
13
10. Unscrew hinge bracket.
11. Remote the cover, turn it through 180°
and re-fit it on the opposite side.
12. Screw hinge bracket into place.
13. Insert the pin into the left-hand door mounting.
Use your index finger to hold the pin while you are
assembling the door.
14. Locate the door on the upper pin as
shown in the illustration and guide it
to the lower hinge bracket.
Important
As a result of its heavy weight, the door
must be held secure by one person.
15. Lift the door upwards and turn the
pin until it fits into the bore hole of
the hinge bracket.
Slowly lower the door downwards.
The lower part of the pin must be
fully engaged in the bore hole of
the hinge bracket.
16. Screw the screw into the
pin again and tighten.
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch
it off and disconnect the plug or switch off or unscrew the fuse.
Clean the appliance and leave the door open in order to prevent
unpleasant smells.
The appliance complies with the relevant safety regulations and
EC Directives 2004/108/EC and 2006/95/EC.
16
14
15
10
12
11
18
17
Adjusting the lateral tilt of the door
If the door is at an angle, adjust the angle.
17. Remove middle screw from hinge bracket.
This screw is no longer needed.
18. Undo screws and slide hinge
bracket to the right or left.
Tighten screws.