Liebherr K 2734 Comfort - Manual (Page 9)

6.1.2 Defrosting freezer compartment*
A layer of frost and ice forms in the freezer compartment after
the appliance has been in use for a lengthy period of time. This
is quite normal. The layer of frost and ice forms more quickly if
the door is opened frequently or if the food is warm when
placed inside. However, a thick layer of ice will increase the
appliance‘s energy consumption. You should therefore defrost
the appliance regularly.
CAUTION
Risk of injury and damage as a result of hot steam!
u Do not use electric heaters or steam cleaners, naked flames
or defrosting sprays for defrosting.
u Do not remove ice using sharp instruments.
u Switch off the appliance.
u Pull out the plug.
u Leave the compartment and appliance door open during
defrosting.
u Remove detached pieces of ice.
u If necessary, pick up defrost water several times, using a
sponge or cloth.
u Clean the compartment (see 6.2) .
6.2 Cleaning the appliance
WARNING
Risk of injury and damage as a result of hot steam!
Hot steam can lead to burns and can damage the surfaces.
u Do not use any steam cleaners!
NOTICE
Incorrect cleaning damages the appliance!
u Do not use cleaning agents in concentrated form.
u Do not use any scouring or abrasive sponges or steel wool.
u Please do not use any aggressive, scouring, sand-,
chloride-, chemical- or acid-based cleaning agents.
u Do not use chemical solvents.
u Do not damage or remove the type plate on the inside of the
appliance. It is important for the customer service.
u Do not pull off, bend or damage cables or other compo-
nents.
u Do not allow any cleaning water to enter the drain channel,
ventilation grille or electrical parts.
u Please use soft cleaning cloths and a universal pH-neutral
cleaning agent.
u Please use cleaning and care products suitable for contact
with foodstuffs in the appliance interior.
u Empty appliance.
u Pull out the power plug.
u Clean the vent grille regularly.
w Dust deposits increase energy consumption.
u Clean plastic outer and inner surfaces with lukewarm
water and a little washing-up liquid.
u Clean drain hole: Remove
deposits with a narrow instru-
ment, e.g. a cotton bud.
u Clean items of equipment by hand with lukewarm water
and a little washing-up liquid.
After cleaning:
u Wipe dry the appliance and items of equipment.
u Connect the appliance and switch it on again.
u Put the food back inside.
6.3 Changing the interior light
In the device, an LED lamp is used as standard illumination for
the interior space.
When an incandescent bulb is used:
q
Use an incandescent lamp with max. 15 W and E14 socket.
q
Power supply (AC) and voltage at the operating point must
comply with the details on the rating plate (see Appliance at
a glance).
When a LED is used:
q
Use only the original LED lamp from the manufacturer. The
lamp can be obtained through customer service or a
specialist dealer (see 6.4) .
WARNING
Risk of injury from LED light!
The light intensity of the LED lighting corresponds to laser
class 1/1M.
If the cover is removed:
u Do not look directly into the light at close quarters through
optical lenses. Doing so may damage your eyes.
WARNING
Fire hazard from the LED light!
If different LED lights are used, there is a danger of overheating
or fire.
u Use the manufacturer's original LED light.
If the lamp is defective, exchange it as follows:
u Switch off the appliance.
u Pull out the power plug or switch
off the fuse.
u Take hold of the lamp cover.
u As shown in the diagram, press
open the lamp cover on the
inside at the front, and pull it off to
the side.
u Replace the lamp.
u Put on the lamp cover again and
snap it into place.
6.4 Customer service
First check whether you can correct the fault yourself by refer-
ence to the list (see Malfunction). If this is not the case, please
contact the customer service whose address is given in the
enclosed customer service list.
WARNING
Risk of injury if repair work is not carried out professionally!
u Have any repairs and action - not expressly specified - on
the appliance and mains cable carried out by service
personnel only. (see Maintenance)
Maintenance
* Depending on model and options 9