Liebherr WTUes 1653 Vinidor - Manual (Page 6)

Switching the appliance on and off
You are recommended to clean the appliance before switching it on for the first time
(see
"Cleaning"). Connect the appliance to the mains - the appliance is switched on.
The alarm will sound when the appliance is switched on for the first time and when the
appliance is warm. Press the
"Alarm" button to switch it off. The temperature display
will also flash.
• To switch the appliance off: Keep the "ON / OFF" button pressed
for 3 sec. so that the temperature display goes out.
• To switch the appliance on: Press the "ON / OFF" button until the
Display lights up.
Setting the temperature
The temperature of both compartments can be set separately.
To reduce the temperature: Press the DOWN button;
- on the left for the upper compartment, on the right for the lower compartment.
To increase the temperature: Press the UP button.
- While you are entering the temperature, the set
temperature will flash on the display.
- You can change the settings in increments of 1°C
briefly pressing the button again.
- The electronic controls will switch over automatically about 5 seconds after the
last time you pressed the button, and the actual temperature will be displayed.
If "F0" or "F1" appears in the display, the appliance has a fault. Consult your nearest
customer service point, quoting the
type of appliance, index and appliance number.
Fan button
Should you wish to use the wine cooler to store wine for long periods of
time, activate the "Ventilation" button. The light in the button comes on.
Thereby a climate which corresponds to that of a wine cellar is achieved
inside the wine cooler. Corks are prevented from drying out due to an
increased level of humidity.
18