Liebherr FT 2902 - Manual (Page 5)

GB
Cleaning
Clean the appliance at least twice per year.
Before cleaning always switch off the appliance.Pull out
the mains plug or remove/unscrew the fuse.
• Remove the plug from the drain
opening.
• To collect the thawed water, place a
flat container below the refrigerator.
• Clean the inside, equipment parts
and outer walls with lukewarm water
and a little detergent.
We recommend the use of an all-
purpose cleaner with neutral pH.
Do not use abrasive or acid cleaners
or chemical solvents.
• Ensure that no cleaning water penetrates into the electrical
components or ventilation grille.
• Dry all parts well with a cloth.
• The ventilation grilles should be cleaned regularly. Dust deposits
increase energy consumption.
Do not use steam cleaners because of the
risk of injury and damage.
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch
it off and disconnect the plug or remove the fuse.
Clean the appliance and leave the lid open in order to prevent
unpleasant smells.
The permissible room temperature for storing the appliance
after decommissioning is between -10°C and +50°C.
Storing the appliance outside this temperature range can
damage the appliance and cause it to malfunction.
The appliance complies with the relevant safety regulations and
EC directives 2004/108/EC and 2006/95/EC.
FT 2900
FT 2902
Special features
Barrel lock
Place the barrel lock in the opening provided in the lid, turn the
key and remove.
Malfunctions
You may be able to rectify the following faults by checking
the possible causes yourself:
• Appliance does not function:
– Is the appliance switched on?
– Is the plug correctly fitted in the mains socket?
– Is the socket fuse intact?
• The temperature is not low enough:
– Is the temperature setting correct (see Setting the tempera-
ture)?
– Have excessive amounts of fresh food been placed in the ap-
pliance?
– Does the separately installed thermometer show the correct
reading?
– Is the ventilation system working properly?
– Is the appliance set up too close to a heat source?
If none of the above causes
apply and you cannot rectify
the fault yourself, contact the
nearest customer service
department stating the type of
appliance
1
, service number
2
and appliance number
3
as indicated on the type plate.
The position of the type plate is shown in the section entitled
Description of the appliance.