Liebherr FT 2902 - Manual (Page 4)

Setting up
• Avoid positioning the appliance in direct sunlight or near cook-
ers, radiators and similar sources of heat.
• The floor on which the appliance stands must be horizontal
and level.
• Standard EN 378 specifies that the room in which you install
your appliance must have a volume of 1 m 3 per 8 g of R 600a
refrigerant used in the appliance, so as to avoid the formation of
inflammable gas/air mixtures in the room where the appliance
is located in the event of a leak in the refrigerant circuit. The
quantity of refrigerant used in your appliance is indicated on
the type plate.
1 Do not cover the gap between the lower edge of the appliance
and the floor, as the refrigeration unit has to be supplied with
air for cooling.
2
There must be a gap of at least 20 cm between
the ventilation grille and the wall. This gap must
be kept clear and the ventilation openings un-
covered.
3 Do not place any
objects immediately
next to the outer hous-
ing of the appliance.
There must be a gap
of at least 20 mm all
round in order to en-
sure adequate heat
discharge.
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the
type plate. The position of the type plate is shown in the section
entitled Description of the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appli-
ance and must be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Dimensions
(mm)
Model Height Width Depth
FT 2900 910 1030 628
FT 2902 900 1030 628
Switching the appliance on and off
You are recommended to clean the interior of the appliance before
switching it on for the first time (see Cleaning).
Switching the appliance on
Connect the appliance to the mains - the ap-
pliance is switched on.
Switching the appliance off
Pull out the mains plug or set the temperature
control to 0.
Important
When the temperature control is turned to "0", the refrig-
eration system is switched off, but the appliance is not
completely disconnected from the mains.
Before cleaning, always disconnect the appliance from the
mains. Remove the plug.
Setting the temperature
Set the temperature inside the
appliance using the temperature
control.
The nearer the temperature
control is to the max. setting, the
colder the interior temperature.
Set the control between "0" and "max."
as required.
Stacking mark
The appliance must not be
filled higher than the stacking
mark on the
interior container.