Liebherr CBNes 6256 PremiumPlus BioFresh NoFrost - Manual (Page 12)

Cleaning
Before cleaning always switch off the appliance. Pull out the
mains plug or switch off or unscrew the fuse.
Clean the inside, equipment and outer walls with lukewarm water
and a little detergent. Do not use abrasive or acid cleaners or
chemical solvents.
Do not use steam cleaners because of the risk of injury and
damage.
• Ensure that no cleaning water penetrates into the electrical
components or ventilation grille.
• Dry all parts well with a cloth.
• Do not damage or remove the type plate on the inside of the
appliance. It is very important for servicing purposes.
• Use a commercially available stainless-steel cleaning agent for
stainless-steel appliances.
- In order to achieve best possible protection, apply a stainless-steel
care agent uniformly in grinding direction after cleaning. Points
which are darker at the start and a more intensive coloration of
the stainless-steel surface are normal.
- Do not use abrasive sponges or scourers, do not use concentrated
cleaning agents and never use cleaning agents containing sand,
chloride or acid or chemical solvents, as these would damage
the surfaces and could cause corrosion.
Defrosting
Refrigerator compartment
The refrigerator compartment defrosts automatically. The water that
forms on the rear wall drains into a reservoir at the back of the appli-
ance and evaporates automatically through the compressor heat.
Freezer compartment
The NoFrost system automatically defrosts the appliance.
Any moisture arising collects on the evaporator and freezes, and
is periodically defrosted and evaporated.
Removing the freezer drawer containers
• Open the refrigerator door.
• Pull out the freezer drawer.
• Pull the container upwards by the right and left corners (1).
• Push the container backwards (2).
• Tilt the container at an angle and remove.
• Install the container in the reverse order.
Side view of the freezer
drawer pulled out
24