Liebherr GN 2723 Comfort NoFrost - Manual (Page 7)

Fig. 7
u Lift the stopper Fig. 7 (12) out of the door bearing bush and
transfer it.
u Detach door handle, stoppers Fig. 7 (10) and pressure
plates Fig. 7 (11) and transfer to the opposite side.
u When mounting the pressure plates, make sure they snap
into place properly.
u Transfer the spring clamp
Fig. 8 (20) : Depress the
latch nose and pull the
spring clamp off over it.
u Slide the spring clamp into
place on the new hinge
side until it clicks into
place.
u Pull the bearing pin
Fig. 8 (21) out of the door
bush and transfer it to the
opposite side together with
the washer. The latch nose
must point to the inner side
of the door, the notch to
the outer side.
Fig. 8
u Hang the door on the bearing pin Fig. 6 (9) at the top.
u Swing the door in at the bottom and insert the bearing pin
Fig. 8 (21) into the turn hinge. If necessary, turn the bearing
pin until it snaps into place.
u Insert the securing screw Fig. 4 (1) at the bottom into the
bearing pin and tighten it (with 4 Nm).
u If necessary, align the door flush with the appliance housing
using the two slots in the turn hinge. To do so, unscrew the
middle screw.
WARNING
Risk of injury due to the door dropping out!
If the bearing parts are not screwed into place firmly enough,
the door may drop out. This may lead to severe injuries. What
is more, the door may not close and therefore the appliance
may fail to cool properly.
u Screw on the bearing brackets/bearing pins tightly (4 Nm).
u Check all of the screws and retighten if necessary.
4.4 Insertion into a row of kitchen units
Fig. 9
(1) Stack cabinet (3) Kitchen cabinet
(2) Appliance (4) Wall
x For appliances supplied with wall spacers, the measurement
increases by 35 mm (see 4.2) .
The appliance can be inserted into a row of kitchen units. To
match the appliance Fig. 9 (2) to the height of the row of units,
a suitable stack cabinet Fig. 9 (1) can be fitted above the appli-
ance.
When installing with kitchen units (max. depth 580 mm), the
appliance can be positioned directly next to the kitchen cabinet
Fig. 9 (3) . The appliance will project by 34 mm x at the sides and
50 mm x in the centre of the appliance in relation to the kitchen
cabinet front.
Ventilation requirements:
- At the back of the stack cabinet there has to be a ventilation
duct of at least 50 mm depth throughout the width of the
stack cabinet.
- The ventilation space under the ceiling has to be at least
300 cm 2 .
- the larger the ventilation space, the more energy-saving the
appliance is in operation.
If the appliance is installed with the hinges next to a wall
Fig. 9 (4) , the distance between appliance and wall has to be at
least 40 mm. This corresponds to the projection of the handle
when the door is open.
4.5 Disposing of packaging
WARNING
Danger of suffocation due to packing material and plastic film!
u Do not allow children to play with packing material.
Putting into operation
* Depending on model and options 7