Liebherr WKt 5551 GrandCru - Manual (Page 4)

14
Operating and control elements
1 Temperature display
2 Temperature setting buttons
3 Audible warning On/Off button
4 Child lock activated symbol
5 On/off button
6 Fan button
Setting the temperature
Increasing the temperature
Press the Up button.
Reducing the temperature
Press the Down button.
- When pressing one of the buttons for the first time, the display
will start to flash.
- Pressing this button again enables you to change the temperature
setting.
- The electronic controls will switch over automatically about
5 seconds after the last time you pressed the button, and the
actual temperature will be displayed.
Storing wine
If you are storing wine for long periods of time, it should be stored
at a temperature of between 10°C and 14°C.
This is the temperature wine cellars are kept at, and it is just right
to allow wine to mature properly.
The following drinking temperatures are recommended for the
various types of wine.
Red wines: +14°C to +18°C
Rosé wines: +10°C to +12°C
White wines: +8°C to +12°C
Sparkling wines, Prosecco: +7°C to +9°C
Champagne: +5°C to +7°C
Switching the appliance on and off
Switching the appliance on
Press the On/Off button until the temperature display
lights up.
Switching the appliance off
Keep the On/Off button pressed for approx. 3 seconds so that
the temperature display goes out.
Setting up
• Avoid positioning the appliance in direct sunlight or near cookers,
radiators and similar sources of heat.
• The floor on which the appliance stands should be horizontal
and level.Compensate for uneven floors with the adjustable feet.
•
Do not cover ventilation openings
or grille.
• Standard EN 378 specifies that the room in which
you install your appliance must have a volume
of 1 m 3 per 8 g of R 600a refrigerant used in
the appliance, so as to avoid the formation of
inflammable gas/air mixtures in the room where
the appliance is located in the event of a leak in
the refrigerant circuit. The quantity of refrigerant
used in your appliance is indicated on the type
plate on the inside of the appliance.
• Always install the appliance directly against the wall.
• Place the appliance in its final position
at the place of installation.
Extend the adjustable foot at the bottom
hinge bracket until it rests on the floor
and then make a further 90° turn.
Dimensions
WKt 4551 A = 1650 mm
WKt 5551 A = 1920 mm
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the section entitled
Description of the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appli-
ance and must be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conversion
of direct current to alternating current/three-
phase current) or energy-saving plugs. Risk
of damage to the electronic control system!