2setting the temperature, 3supercool, 4shelves – Liebherr TP 1760 Premium User Manual
Page 8: 5using the sectioned shelf, 6door racks, Control
u
Use recyclable plastic, metal, aluminium and glass
containers and cling film for wrapping.
u
Always store liquids and food which is subject to odour or
taste transfer in closed containers or cover them.
u
Foods which give off a large amount of ethylene gas and
delicate foods, such as fruit, vegetables, salad, should
always be stored separately or wrapped so as not to reduce
the storage life; e.g. do not store tomatoes together with
kiwis or cabbage.
u
Do not store food too close together to enable good air
circulation.
u
To safeguard bottles from tipping over: move the bottle
holder.
5.3.2 Setting the temperature
The temperature depends on the following factors:
-
the frequency of opening the door
-
the room temperature of the installation location
-
the type, temperature and quantity of the food
Recommended temperature setting: 5 °C
An average temperature of approx. -18 °C is then established
in the freezer compartment.*
The temperature is changed sequentially. Once the 2 °C
setting is reached, the sequence starts again at 9 °C.
u
Call up temperature function: press the setting
button
Fig. 3 (2)
.
w
The previously-set value will flash in the temper-
ature display.
u
Change the temperature in 1 °C steps: Press the
setting button
Fig. 3 (2)
until the required
temperature is indicated in the temperature
display.
u
Change temperature continually: hold down
setting button.
w
During adjustment the value flashes on the
display.
w
The new setting is adopted approx. 5 seconds after the last
time the button was pressed and the set temperature is
again displayed. The temperature in the interior gradually
adjusts to the new value.
5.3.3 SuperCool*
With SuperCool you switch to the highest cooling
performance to reach lower cooling temperatures.
Use SuperCool, to rapidly cool large amounts of
food.
When SuperCool is activated, the appliance operates with
maximum cooling performance. The noise of the refrigeration
unit may be temporarily louder as a result.
The SuperCool function uses slightly more energy.
Cooling with SuperCool*
u
Briefly press SuperCool button
Fig. 3 (4)
.
w
The SuperCool symbol
Fig. 3 (9)
lights up in the display.
w
The cooling temperature drops to the coldest value.
SuperCool is activated.
w
SuperCool is automatically deactivated after 6 to12 hours
The appliance continues to operate in the energy-saving,
normal mode.
To prematurely deactivate SuperCool*
u
Briefly press SuperCool button
Fig. 3 (4)
.
w
The SuperCool symbol
Fig. 3 (9)
goes out in the display.
w
SuperCool is deactivated.
5.3.4 Shelves
Moving or removing shelves
The shelves have stops preventing them from being uninten-
tionally pulled out.
Fig. 9
u
Lift the shelf slightly and pull forward a little.
u
Adjust the height of the shelf. To do so, push the cut-outs
along the supports.
u
In order to remove the shelf fully, place it at a slant and pull
out towards the front.
u
Insert shelf with the raised edge pointing upwards at the
back.
w
The food does not freeze onto the rear wall.
Dismantling shelves
u
The shelves can be disman-
tled for cleaning.
5.3.5 Using the sectioned shelf
CAUTION
Danger of laceration!
The shelf may break. The broken fragments may cause lacera-
tion.
u
Remove only empty shelves.
Fig. 10
u
The glass shelf with stop face (2) has to be at the back.
u
The glass plate (1) with pull-out stops must be at the front so
that the stops (3) face downwards.
5.3.6 Door racks
Removing the storage rack
Fig. 11
Control
8
* Depending on model and options