Liebherr GN 4113 Comfort NoFrost - Manual (Page 10)

WARNING
Risk of injury if repair work is not carried out professionally!
u Have any repairs and action - not expressly specified - on
the appliance and mains cable carried out by service
personnel only. (see Maintenance)
u Read the appliance
designation
Fig. 11 (1) , service
No. Fig. 11 (2) and
serial No. Fig. 11 (3)
off the type plate
located inside the
appliance on the left-
hand side.
Fig. 11
u Notify the customer service, specifying the fault, appliance
designation Fig. 11 (1) , service No. Fig. 11 (2) and serial No.
Fig. 11 (3) .
w This will help us to provide you with a faster and more accu-
rate service.
u Keep the appliance closed until the customer service
arrives.
w The food will stay cool longer.
u Pull out the mains plug (not by pulling the connecting cable)
or switch off the fuse.
7 Malfunction
Your appliance is designed and manufactured for a long life
span and reliable operation. If a malfunction nonetheless
occurs during operation, check whether it is due to a handling
error. In this case you will have to be charged for the costs
incurred, even during the warranty period. You may be able to
rectify the following faults yourself:
Appliance does not work.
→ The appliance is not switched on.
u Switch on the appliance.
→ The power plug is not properly inserted in the wall socket.
u Check power plug.
→ The fuse of the wall socket is not in order.
u Check fuse.
The compressor runs for a long time.
→ The compressor switches to a low speed when little cold is
needed. Although the running time is increased as a result,
energy is saved.
u This is normal in energy-saving models.
→ SuperFrost is activated.
u The compressor runs for longer in order to rapidly cool the
food. This is normal.
A LED on the bottom rear of the appliance (at the
compressor) flashes regularly every 15 seconds*.
→ The inverter is equipped with a diagnostic LED.
u The flashing is normal.
Excessive noise.
→ Due to the various speed steps, speed-regulated*
compressors can generate different running noises.
u The sound is normal.
A bubbling and gurgling noise.
→ This noise comes from the refrigerant flowing in the refriger-
ation circuit.
u The sound is normal.
A quiet clicking noise.
→ The noise is produced whenever the refrigeration unit
(motor) automatically switches on or off.
u The sound is normal.
A hum. It is briefly a little louder when the refrigeration
unit (the motor) switches on.
→ The refrigeration increases automatically when the
SuperFrost, function is activated, fresh food has just been
placed in the appliance or the door has been left open for a
while.
u The sound is normal.
→ The ambient temperature is too high.
u Solution: (see 1.2)
Vibratory noise.
→ The appliance is not fixed to the ground. The running of the
cooling unit therefore makes objects and adjacent furniture
vibrate.
u Adjust appliance via the height-adjustable feet.
u Move bottles and containers apart.
The SuperFrost button flashes together with the tempera-
ture display.
→ There is a fault.
u Please contact the after-sales service (see Maintenance).
All LEDs light up in the temperature display.
→ Demo mode is activated.
u Please contact the after-sales service (see Maintenance).
The outer surfaces of the appliance are warm*.
→ The heat of the refrigeration circuit is used to prevent
condensate from forming.
u This is normal.
The temperature is not cold enough.
→ The door of the appliance is not properly closed.
u Close the door of the appliance.
→ Insufficient ventilation.
u Clear ventilation grilles.
→ The ambient temperature is too high.
u Solution: (see 1.2) .
→ The appliance was opened too frequently or for too long.
u Wait to see whether the appliance reaches the required
temperature by itself. If not, please contact the after sales
service (see Maintenance).
→ Too much fresh food was placed inside without SuperFrost.
u Solution: (see 5.6)
→ The appliance is too close to a source of heat (stove, heater
etc).
u Change the position of the appliance or the source of heat.
The interior light is not on.
→ The appliance is not switched on.
u Switch on the appliance.
→ The door was open longer than 15 min.
u The interior light automatically switches off if the door has
been open for about 15 min.
→ If the interior light is not on but the temperature display is lit,
the bulb is faulty.
u Change the bulb (see Maintenance).
8 Decommissioning
8.1 Switching off the appliance
u Press the On/Off button Fig. 3 (1) until the display goes
dark. Release button.
w If the appliance cannot be switched off, the child lock func-
tion is active .
8.2 Taking the appliance out of service
u Empty the appliance.
Malfunction
10 * Depending on model and options