Blaupunkt ACD 9431 - Manual (Page 7)

ACD 9431
16
Balance and Fader Control
Balance control
To balance the sound level left/right:
•
Press the AUD button 2 until bal is
shown on the display.
Press rocker switch < >
7 on the left
or right to adjust the sound impression
according to your personal preferences.
Display
9 gives you a number bet-
ween -9 and +9.
Fader control
To balance the front/rear sound level:
•
Press the AUD button 2 until fad is
shown on the display.
Press rocker switch < >
7 on the left
or right to adjust the sound impression
according to your personal preferences.
Display
9 gives you a number bet-
ween -9 and +9.
Note:
If the rocker switch < > is kept depressed (on
the left or right), the set quickly advances to
the final values (+7/+9 or -7/-9) or to the “0”
position.
Radio Section
Selecting the Desired Waveband
With this set you have free choice from the
following wavebands:
FM (ultra-short wave; frequency-modulated),
MW (medium wave), and LW (long wave).
Selecting FM
•
Press the FM•T button 3 briefly. “FM”
lights up on display 9 a.
Selecting MW or LW
•
Press the M•L button 4 briefly. Either
“MW” (for medium wave frequencies) or
“LW” (for long wave frequencies) lights
up on display
9 g, c.
For changing between MW and LW:
•
Press the M•L button 4 once again.
Tuning in a Station Automatical-
ly
Tuning in the following station
•
Press the < > rocker switch 7 on the
right. The car stereo automatically
starts searching for the next station.
Tuning in the previous station
•
Press the < > rocker switch 7 on the
left. The car stereo automatically starts
searching for the previous station.
If the < > rocker switch 7 is kept de-
pressed on the right or the left, the sta-
tion seek operation continues to be
carried out quickly in the corresponding
direction.
Manual Tuning
To manually tune in a station,
•
press the lo•m button 5 until “m” lights
up on display 9 f.
You can now manually search for the desired
stations via the < > buttons
7 .
Adjusting the Station Seek
Sensitivity
With this set you can modify the automatic
station seek sensitivity in all wavebands.
If you want to search for strong stations only
(reduced sensitivity):
•
Press the lo button 5 until “lo” lights
up on display 9 e.
If you also want to search for weaker stations
(increased sensitivity):
•
Press the lo button 5 once again; the
“lo” indication on display 9 e goes out.