Billy Goat MV650H - Manual (Page 13)

Form No F030106A 13 Part No 840186
MV650H PUSH Vacuum Owner’s Manual
O
PERATOR
C
ONTROLS
The operator’s position is at the rear of the machine between the handlebars. The operator should STAND in a
position to allow both handlebars to be grasped firmly, which allows sufficient leverage to steer the machine.
Operator’s controls are shown below.
Operator Control Locations
1 Nozzle Door Adjuster 4 Throttle Control
2 Bag Latch
3 Pull Starter
S TARTING
CHECK engine oil level before operating machine.
1. Place equipment on a level, firm surface that is free of rocks or other debris.
2. Place throttle in CHOKE position.
Throttle
DO NOT START equipment without the debris bag in place.
2
3
4
1