Glen Dimplex Home Appliances Ltd Front & Side Control Gass Hobs 70T - Manual (Page 15)

Fit the hob into the cutout &
secure to worktop
Place the hob into the cutout and
secure in place using the four brackets
and screws provided.
The brackets should be orientated to
suit the worktop thickness as shown,
then inserted into the four slots (two on
the front edge and two on the rear)
and screwed into the underside of the
worktop using the woodscrews provid-
ed.
The screws should be tightened just
sufficiently to secure the hob and pull
the top pressing flush with the work-
top.
If the base of the hob is accessible
after installation then a partition must
be fitted 20mm below the base to pre-
vent access.
seal
hob
40mm
worktop
seal
hob
30mm
worktop
15