beautypg.com

Problems and solutions guide – Barbie LIL' TRAIL RIDER K0451 User Manual

Page 17

background image

PROBLEMS AND SOLUTIONS GUIDE

PROBLEM

POSSIBLE CAUSE

SOLUTION

Vehicle does not run

Undercharged battery

Charge the battery. A new battery should have been

charged for at least 18 hours before using the vehicle for

the

fi rst time. After fi rst-time use, recharge the battery for

at least 14 hours after each use. Never charge the battery

longer than 30 hours.

Check all connectors. Make sure the battery connector is

tightly plugged into the charger connector, and that the

charger is plugged into the wall.

Make sure power fl ow to the wall outlet is “ON”.

Charger is not working

There is no sure way to tell if your charger is working unless

you have a volt meter. If you suspect there is a problem with

your charger, contact your local Power Wheels

®

authorized

service center. They can test your charger for you.

Tripped thermal fuse

The built-in thermal fuse may "trip" and shut down operation
of the vehicle if the vehicle is overloaded or the driving
conditions too severe. Once a fuse has "tripped", release
the button on the handlebar and wait 25 seconds before
operating the vehicle again. To avoid repeated automatic
shutdowns, do not overload the vehicle by exceeding the
40 lb maximum weight capacity or by towing anything behind
the vehicle. Do not drive up hills or run into fi xed objects,
which can cause the wheels to stop spinning while power
is still being supplied to the motors. If a thermal fuse
continually trips, contact your local Power Wheels

®

authorized

service center.

Loose wires or loose connectors

Check all wires and connectors. Make sure the battery

connector is tightly plugged into the motor connector and that
there are no loose wires around the motors.

Dead battery

If your battery is old or if you have not followed Battery

Care instructions, your battery may be dead. If you are

unsure whether or not the battery is dead, you can have

it tested at your local Power Wheels

®

authorized

service

center.

Electrical switch damage

The electrical switches can become corroded due to
exposure to water or moisture, or can jam due to loose dirt,
sand or gravel. Contact your local Power Wheels

®

authorized

service center for diagnosis and repair.

Motor damage

Contact your local Power Wheels

®

authorized service center

for diagnosis and repair.

IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions Guide below. If you still
experience a problem, please contact Power Wheels

®

Consumer Relations, toll-free at 1-800-348-0751. Or, contact your local

Power Wheels

®

authorized service center. For the location nearest you, please visit us on-line at www.powerwheels.com, or call

1-800-348-0751.

17

J4030pr-0920

17

K0451pr-0921