Philips Casque hi-fi sans fil - Manual (Page 4)

E
N
G
LI
SH
1.3 General information
• To prevent fire or shock hazard: always keep
this product dry and do not expose it to
excessive heat by heating equipment or
direct sunlight.
• Do not allow your headset to be submerged
in water.
• To clean the product use a slightly dampened
chamois cloth. Do not use cleansing agents
containing alcohol, spirits, ammonia or
abrasives as they may harm the product.
• Do not disassemble the product.
• Transmission range : 30 meters, depending on
ambient conditions.
• Do not operate or store in a place where
temperature is below 0˚C (32˚F) or above
40˚C (104˚F) as this may shorten your
battery life.
• Only use Philips’ rechargeable shortened
sleeve NiMH batteries with your headphones.
• Apparatus shall not be exposed to dripping or
splashing.
• The main plug of AC/DC adapter is used as the
disconnect device, the disconnect device shall
be readily operable.
• Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such as
sunshine, fire or the like.
1.4 Disposal of your old product
Your product is designed and
manufactured with high quality materials
and components, which can be recycled
and reused.
When this crossed-out wheeled bin symbol is
attached to a product, it means the product is
covered by the European Directive 2002/96/EC.
Please be informed about the local separate
collection system for electrical and electronic
products.
Please act according to your local rules and do
not dispose of your old product with your normal
household waste. The correct disposal of your
old product will help prevent potential negative
consequences to the environment and human
health.
1 Important
1.1 Hearing safety
Danger
To avoid hearing damage limit the time you use the
headphones at high volume and set the volume to
a safe level. The louder the volume the shorter is
the safe listening time.
Be sure to observe the following guidelines
when using your headphones.
• Listen at reasonable volumes for reasonable
periods of time.
• Be careful not to adjust the volume
continuously upwards as your hearing adapts.
• Do not turn up the volume so high that you
can’t hear what’s around you.
• You should use caution or temporarily
discontinue use in potentially hazardous situations.
• Excessive sound pressure from earphones and
headphones can cause hearing loss.
1.2 Electric-, Magnetic- and
Electromagnetic Fields (“EMF”)
1 Philips Electronics manufactures and sells
many products targeted at consumers,
which, like any electronic apparatus, in
general have the ability to emit and receive
electromagnetic signals.
2 One of Philips leading Business Principles is
to take all necessary health and safety
measures for our products, to comply with
all applicable legal requirements and to stay
well within the EMF standards applicable at
the time of producing the products.
3 Philips is committed to develop, produce and market
products that cause no adverse health effects.
4 Philips confirms that if its products are
handled properly for their intended use, they
are safe to use according to scientific evidence
available today.
5 Philips plays an active role in the development
of international EMF and safety standards,
enabling Philips to anticipate further
developments in standardization for early
integration in its products.
1.5 Notice for the European Union
Hereby, Philips Consumer Lifestyle,
BU P&A, declares that this Philips
digital wireless headset SHD8900 is in compliance
with the essential requirements and other relevant
provisions of Directive 1999/5/EC. This product has
been designed, tested and manufactured according
to the European R&TTE Directive 1999/5/EC.
2 What’s inside the box
1. Headphones
2. Docking station
3. AC/DC adapter (Traveling adapter
with EU and UK plug)
4. 3.5-6.3mm adapter
5. RCA audio cable
6. Jack to cinch connector
7. 3 x AAA rechargeable shortened
sleeve NiMH batteries (SBC HB700)
8. User manual
3 Get started
Select the appropriate plug
Important!
• Make sure the plug you selected
corresponds to the local socket
requirement.
Installing/ replacing batteries
Important!
• Only use Philips rechargeable
shortened sleeve NiMH batteries
with your headphones for charging.
Note that other types of
rechargeable or alkaline
batteries cannot be charged with
this system.
A
B
C
• Remarks : AAA alkaline batteries can
be used to operate the headphones.
Power on the transmitter
Charging the headphones
Important!
• The energizing docking station does
not transmit audio signal when
charging is activated.
• Before using the headphones for the
first time, please ensure the
batteries are fully charged for at
least 4 hours.
Audio Connection and
adjusting ATT (Attenuation of
audio input signal)
Important!
• Achieve a better volume level, please
Set ATT to 0dB : Portable CD player,
MP3 player or other devices with
3.5mm triport socket output
Set ATT to -8dB : HiFi, TV, DVD
player or other devices with RCA
socket output
• In case your audio source has a
6.3mm headphone output, use the
supplied 3.5mm to 6.3mm stereo
adapter plug.
• The volume of the sound source
must be sufficient, otherwise the
transmitter automatically turns off.
Power on/off
Mute
Important!
• You can temporarily mute the
audio source by keep pressing and
holding the “Mute” button. Once the
“Mute” button is released, audio will
be back.
D
E
F
G
H
3 2