Beko D 6102 B - Manual (Page 8)

8
again.
• If “washing” led on program progress display is blinking
either there is no water or tap is off. Check your taps.
Turn your machine off and on. If the problem persists
unplug your machine, turn off tap water and call
authorized service.
• If program is started or program selection can not be
performed your machine might be in protection mode
due to infrastructure problem (voltage, water pressure,
etc.) Press and hold the > Start/Pause/Cancel < button
for 3 seconds in order to switch machine to factory
settings. Simultaneously, “Cancel” will appear on the
display.
• Most of the warnings resulting in calling an authorized
service are due to infrastructure problems. For
this reason applying to an Authorized Service is
recommended.