Beko D 6102 B - Manual (Page 21)

21
Connection points are below water pressure there turn on
tap water after connection. Check all connections for leaks
In order to eliminate any risk due to water leakage keep
the taps off when machine is not used.
Your machine will operate efficiently if the water from tap is
minimum 1 and maximum 10 bars. Practically 1 bar means
8 liters of water in one minute when tap is fully on.
Connect dirsekli end to the machine. Tighten bolts with
hand power, do not use spanner.
Double inlet models can be used with blind cap as a single
inlet machine. Connect blind cap to hot water inlet. Seal
must be for stopping water leakage.
Do not connect single inlet machine to hot water. If ma-
chine is connected with Y part to a double inlet and over
40˚C for single inlet machines, machine may switch to
protection mode.
b) Water drain hose
Water drain hose could be placed either at the side of the
bath tub, or directly to the drain. The hose should not be
bent. Water drain hose should be secured with the elbow
so that it would not fall down on the ground.
The hose should be placed between 40 and 100 cm. from
the ground.
Water drain hose could be placed directly to the drain
water inlet.