How to use – Black & Decker CO100 User Manual

Page 6

12. Now, use your ruler or the paper ruler provided to measure the overhang

molding height, placing your ruler vertically against the underside of the

cabinet behind the overhang molding. This number determines the number of

spacers you need, using a number of spacers equal to the overhang molding

height. For example, a 1” overhang molding would use 2, ½” spacers on each

of the rear holes

(K).

13. Drop one of your screws through each of the washers covering the holes in the

cabinet, from inside the cabinet down.

Note: To determine which screws to use, you must have enough of the screw

exposed underneath the cabinet to properly thread the screw into the nut.

14. Place the appropriate number of spacers determined in step 12 on both of the

rear screws to ensure the appliance will be even

(L).

Note: If the height of your overhang molding is too tall to be accommodated by

the number of spacers provided, you may call, toll-free, at 1-800-231-9786 to

order additional spacers at no charge.
Note: For spacer installation, you may require assistance in mounting in order to

hold spacers in place while securing the appliance at the same time. If assistance

is not available, use a small clamp to hold the spacers in place while you position

the appliance.
15. Once spacers are set, hold appliance up and tighten screws to secure. Screw

from inside the cabinet down.

Note: Always tighten screws to ensure the appliance does not move or shake

during operation.
16. Pull out cord from cord storage behind appliance and plug into standard

electrical outlet. Extra cord can be fed back into storage or hung over cord

management hook behind unit

(see illustration F).

Note: If you are connecting this appliance to the receptacle of another

†SpaceMaker™ appliance such as the toaster oven or coffeemaker, make sure you

can easily unplug the appliance following use.
17. Your †SpaceMaker™ appliance is now ready for use!

How to Use

This appliance is for household use only.
OPENING A CAN
1. Lift piercing lever.
2. Tip can so that the rim is under the locating post, then push down on the piercing

lever, making sure the cutter blade is inside the rim of the can

(M).

Note: Because of the hands-free feature, it is not necessary to hold the lever down

or hold the can during cutting. However, you may have to support very tall or heavy

cans.
Tip: When the can is opened, the can opener will stop automatically.
3. To remove the can, hold it with one hand and raise the lever with the other.
Caution: Avoid contact with the cut edges of the can or lids — they are sharp. During

opening process, the design of your can opener will roll the rim of the can to prevent

sharp edges; however, handle with caution and always handle cut lid with caution, as

these edges are not rolled.
4. Carefully discard the lid from the magnet.
Important Tips:
• Do not use this can opener to open cans with a pull tab, peel-off foil seal,

or rolling key or rimless cans.
• Open frozen juices or foods in cardboard cans right from the freezer, while they

are frozen.
• Aluminum lids will not stick to the magnet.