B&K AVR101 Series 100 - Manual (Page 42)

ZONE CONFIGURATION
Zone Configuration will allow you to set maximum volume levels for each zone, change remote control ID codes
for each zone and turn off the on-screen display overlays in zone 1. Make sure you are in the ADVANCED
SYSTEM SETUP menu and the remote is in AUDIO mode.
Z1 Max Level - Z1 max level allows you to set a maximum volume level for zone 1. This is very useful if you are
using speakers that can’t handle the maximum power output from your receiver or if you simply wish to limit the
volume that can be achieved using normal front panel or remote operation.
WARNING - If you set this level too low, the receiver may appear broken (no sound).
ADVANCED ZONE SETTINGS
2 Z1 Product ID 1
3 Z1 On Screen Enabled
= 0$; /9/
move to new line
previous page
↑ ↓
M E N U
4 Z2 Level Control Variable
5 Z2 Max Level +15 dB
ADVANCED SYSTEM SETUP
1 Zone Configuration
2 Power On Titles
=21( 6(783
move to new line
previous page
↑ ↓
M E N U
select menu page SEL
3 Control Out
4 Security Options
1 Z1 Max Level +15 dB
6 Z2 Product ID 2
adjust parameter
←→
set desired maximum level VOLUME KNOB ˆ
(REW) or
‡
(FF) 4
move to Z1 Max Level ∧
(UP) or
∨
(DOWN) ­ (PAUSE) or V (STOP) 3
activate ADVANCED ZONE SETTINGS
↵
(ENTER) SEL or ENTER 2
move to Zone Configuration ∧
(UP) or
∨
(DOWN) ­ (PAUSE) or V (STOP) 1
Action From Front Panel From Remote
40 p/n 12699 Rev. 9808B