beautypg.com

6 active protection system is activated – Philips AquaTrio Système d'aspiration et lavage User Manual

Page 13

background image

13

2

Open the mopping nozzle lid (1), remove the

mopping brush cover (2) and take out the

object (3). If you cannot find the object, you

can remove the mopping brushes to have a

better look.

3

If the active protection system was activated

because the mopping brushes are too wet,

remove the mopping brushes and squeeze

them over the sink (see chapter ‘Cleaning and

maintenance’, section ‘ Cleaning the mopping

nozzle’).

4

Place the mopping brush cover (1) and close

the mopping brush lid (2). Press the mopping

nozzle lid (3) to lock it (‘click’), otherwise the

appliance is not reset.

5

Put the plug in the wall socket. Press the

nozzle with your foot and release the

appliance from parking position. Push the

unlock slide forwards (1) and press and hold

the power-on button (2). You can release the

unlock slide when the appliance switches on

(3). Keep the power-on button pressed to

continue cleaning.

6

Lift and hold the lever (1) and slide the dirty

water tank back into the appliance completely

(2). Press down the lever (3) to lock the

dirty water tank into place (‘click’). Make sure

the lever for the dirty water tank is locked

properly. If the lever is not locked properly, the

dirty water tank may fall out during cleaning.

5.6 Active protection system is

activated

The active protection system has been designed

to recognise when a foreign object other than dirt

or liquid is picked up from the floor. When the

system is activated, it stops the mopping brushes

immediately to prevent damage to the object and

appliance. The motor sound decreases and the

appliance no longer applies water to the floor. The

active protection system is also activated when

the mopping brushes are too wet or when you

move the appliance over a carpet. To continue

cleaning, follow the instructions below!

1

Release the power-on button to switch off

the appliance (1). Put the appliance upright

in parking position (‘click’) and pull the plug

out of the wall socket. If the object picked up

is the cord of another appliance, unplug this

appliance as well (2).

EN

g

LI

sh

This manual is related to the following products: