Belkin BASIC F7D1101AK - Manual (Page 34)

32
fCC statement
deClaraTIOn Of COnfOrMITY WITH fCC rUles
fOr eleCTrOMagneTIC COMPaTIbIlITY
We, Belkin International, Inc ., of 12045 Waterfront Drive, Los
Angeles, CA 90094, declare under our sole responsibility that the
product, F7D1101, to which this declaration relates, complies with
Part 15 of the FCC Rules . Operation is subject to the following two
conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received,
including interference that may cause undesired operation .
Caution: Exposure to Radio Frequency Radiation . The radiated
output power of this device is far below the FCC radio frequency
exposure limits . Nevertheless, the device shall be used in such
a manner that the potential for human contact during normal
operation is minimized . When connecting an external antenna
to the device, the antenna shall be placed in such a manner to
minimize the potential for human contact during normal operation .
In order to avoid the possibility of exceeding the FCC radio
frequency exposure limits, human proximity to the antenna shall
not be less than 20cm (8 inches) during normal operation .
federal Communications Commission notice
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules . These limits are designed to provide reasonable protection
against harmful interference in a residential installation .
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications .
However, there is no guarantee that interference will not occur
in a particular installation . If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected .
• Consult the dealer or an experienced radio/TV technician for help.
InfOrMaTIOn