Glen Dimplex Home Appliances Ltd GT 756 - Manual (Page 6)

%NMI hook
;rot '4'ppl:c:d .
)
coc.kef rear
Gas Supply worktops (excluding handles). To achieve the best fit the cooker must be pushed against the
wall. If the wall mounted adapter backplate (Fig.1) is to be fitted behind the appliance then
the suitable area for this fitting is shown as the area in (Fig.2).
The temperature rise of areas at the reara of the cooker that are likely to come into contact
with the flexible hose do not exceed 70°C. However, do not allow contact of the hose in the
top 150mm/6 inches (the shaded area shown in Fig.3).
A Rp 1 /2 union is fitted to the cooker. Connection to the appliance should be made with an
approved appliance flexible connection to BS669. The length of the hose should be such that
when the cooker is in situ, it does not touch the floor.
Stability Chain The cooker must be secured by a security chain to the wall or partition behind the cooker.
(Fig.4)
Flame Failure All burners are protected by flame failure devices, if the flames are extinguished for any reason
Device the gas will automatically be cut off.
The burner control knobs have a safety feature.
Flame 1 Push the appropriate knob in slightly and turn anti-clockwise to the required setting.
failure
device
2 While keeping the knob depressed press the ignition button. /4;
3 Keep the knob depressed for 15 seconds after the burner has lit to override the safety
device.
If still no ignition occurs, wait for 1 minute and repeat again.
Warning: Do not keep the knob in pressed position more than 15 seconds.
4
To switch a burner off turn the corresponding knob to I.
• Turning the control knob fully anti-clockwise to the small flame symbol enables you to
simmer without accidently switching off.
Fig.1 Fig.2
A=150
B=175
C=700
D=500
E=150
Fig.4 Fig.3
The hose must
not come into
contact with
the shaded
area
6