Philips BEARDTRIMMER Series 3000 barbero para barba y barba de 2 días - Manual

English
introduction
Congratulations on your purchase and welcome to
Philips! To fully benefit from the support that Philips
offers, register your product at www.philips.com/
welcome.
general description (Fig. 1)
A Beard trimming comb
B Cutting unit
C Precision Zoom Lock ` adjustment ring
D Charging light
E Socket for appliance plug
F On/off slide
g Adapter
h Appliance plug
i Cleaning brush
important
Read this user manual carefully before you use the
appliance and save it for future reference.
Danger
- Make sure the adapter does not get wet.
Warning
- The adapter contains a transformer. Do not cut
off the adapter to replace it with another plug, as
this causes a hazardous situation.
- This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
- Children should be supervised to ensure that they
do not play with the appliance.
Caution
- Use, charge and store the appliance at a temperature
between 5°C and 35°C.
- Only use the adapter supplied.
- Never immerse the appliance in water or rinse it
under the tap.
- If the adapter is damaged, always have it replaced
with one of the original type in order to avoid a
hazard.
- This appliance is only intended for trimming the
human beard. Do not use it for any other purpose.
- Do not use the appliance if the cutting unit or the
beard trimming comb is damaged or broken, as this
may cause injury.
Electromagnetic fields
This Philips appliance complies with all standards
regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user
manual, the appliance is safe to use based on scientific
evidence available today.
general
- The appliance is equipped with an automatic voltage
selector and is suitable for mains voltages from 100
to 240 volts.
- The adapter transforms 100-240 volts to a safe low
voltage of less than 24 volts.
Charging
Charge the appliance fully before you use it for the first time.
It takes approximately 10 hours to fully charge the appliance.
When it is fully charged, the appliance has a cordless
operating time of up to 35 minutes.
Note: You can use the appliance cordless as well as
connected to the mains.
1 Make sure the appliance is switched off (Fig. 2).
2 Insert the appliance plug into the appliance (Fig. 3).
3 Put the adapter in the wall socket.
, The charging light on the appliance goes on to
indicate that the appliance is charging.
Note: The charging light does not change colour and does
not go out when the appliance is fully charged.
4 After charging, remove the adapter from the
wall socket and pull the appliance plug out of the
appliance.
Optimising the lifetime of the rechargeable
battery
When you have charged the appliance for the first time,
we advise you to use it until the battery is completely
empty.
Do not recharge the appliance in between the trimming
sessions.
Continue to use the appliance until the motor almost
stops running during a session. Then recharge the battery.
Follow this procedure at least twice a year.
Trimming
Always comb the beard and/or moustache with a fine
comb before you start trimming.
When you trim for the first time, be careful. Do not
move the trimmer too fast. Make smooth and gentle
movements.
Trimming with beard trimming comb
1 Turn the Precision Zoom Lock ` adjustment ring
to the desired setting. (Fig. 4)
See the table below for an overview of the settings and
the resulting hair lengths.
1
4222.002.8019.4
QT4021, QT4019
2 3
9
4
5 6 7
8 9 10
11 12 13
14 15 16
17 18 19
20 21