Philips Purificador de aire - Manual (Page 15)

Pre-filter
The pre-filter is washable.
- Clean the pre-filter when the first filter replacement light flashes to
ensure optimal functioning of the appliance.
1 Place your fingers in the recesses of the side panels and gently pull
the top part of the front panel towards you. Then lift the hooks at
the bottom of the panel out of the bottom of the appliance.
2 To remove the pre-filter, grab the two projections and pull the filter
towards you.
3 Wash the pre-filter under a running tap. If the pre-filter is very dirty,
use a soft brush to brush away the dust.
Tip: Alternatively, you can clean the pre-filter by removing the dust with a
vacuum cleaner.
4 Air-dry the pre-filter.
Note: Make sure that the pre-filter is completely dry. If it is still wet, bacteria
may multiply in it and shorten the lifetime of the pre-filter.
5 Put the pre-filter back into the appliance. Attach all hooks properly
to the appliance.
Note: Make sure that the side with the two projections is pointing towards you.
6 To reattach the front panel, insert the bottom hooks into the bottom
of the appliance first (1). Then push the panel against the body of the
appliance (2).
1
2
English 15
4222.003.4042.1.indd 15 18-09-09 14:17