Bushnell 11-8321 - Manual (Page 4)

4
5. The mode setting operation is a cycle loop, so press the MODE button to switch to another mode.
The loop order of the different modes is shown here:
6. To change settings, toggle through the different modes by pressing the MODE button. When a
mode is selected, the indicator symbol on the LCD will appear. You can then select that mode by
pressing the SNAP button.
7. When in “Normal” mode, press SNAP to take a picture.
Press SNAP->
8. Pressing the MODE button will cause the camera to enter “Mode Change”.
9. To select “Self-Timer” mode, press MODE and the self timer mark appears. Press SNAP and the
capture will be done after 10 seconds. The camera exits self timer mode automatically after the
capture is done and the self timer mark disappears on the LCD at the same time.
Press MODE-> press SNAP to capture.