Philips Mando a distancia universal - Manual (Page 9)

Learn a key
IIf you miss certain functions from your original remote control on the
SRU 5040, the SRU 5040 can learn these functions from the original remote
control.You can store a fuction under any of the available keys onthe
SRU 5040, except LEARN, SELECT and SHIFT. Please, note that any function
already stored under a key will be deleted.
Example for VCR:
Make sure you have the original VCR remote control at hand.
1
Select the device mode VCR, with the
SELECT key.
2
Press the LEARN key and the target key on
the SRU 5040 simultaneously for 5 seconds,
until VCR in the selector window blinks twice
and then remains lit.
3
Place both remote controls on a flat surface
(like a coffee table) and aim them head-to-
head with about 5 - 10 cm in between.
4
Press the button you want to copy on the original remote control.
– If the SRU 5040 has learned the code,VCR in the selector window
blinks twice to confirm the signal is stored.
– If VCR blinks once for a longer period, the IR signal is not learned by the
SRU 5040. Please, try a few times and make sure the remote controls
are aligned as described in step 3.
If the SRU 5040 cannot learn the code after several times trying,
it is possible that:
–
The IR signal of your original device is out of range (the SRU 5040 can
only learn IR signals with a carrier signal of 30-60kHz.
– The memory of the SRU 5040 is full.
– The SRU 5040 stopped the learning process after 20 seconds if no
IR signals are found. Check if your original remote control is working
correctly.
Restoring the original functions of your remote
control
1
Keep keys 1 and 6 on the SRU 5040 pressed
simultaneously for five seconds, until one of
the device indicators (TV, DVD, STB,VCR)
lights up in the selector window.
9
Instructions for use
English