Philips Mando a distancia universal - Manual (Page 10)

Adjusting device selection (Mode selector)
The SRU 7040 is default set for operating TV, DVD (or VCR) STB (settop
box, satellite or cable decoder) and AMP (amplifier).You can select the device
you wish to operate with the SELECT key (mode selector). Each option
allows operation of one device only. If desired, you can program the SELECT
key (mode selector) to select a different kind of device. For example, if you
want to operate a second TV. In the following example you will see how to
configure the STB mode for a second TV.
1
Switch on the second TV.
2
Press the SELECT key to select STB.
Press the key until the STB LED lights up.
3
Then keep keys 1 and 6 on the SRU 7040
pressed simultaneously for three seconds,
until the STB LED lights up.
4
Press keys 9, 9 and 2 in that order.
5
Press the SELECT key to select TV.
Press the key until the TV LED lights up.
6
Press the 1 key.
– The STB LED flashes twice.
STB will now allow you to operate your
second TV.
7
Program the SRU 7040 to operate the second TV.
See ‘Setting the remote control’.
Adding a function to the remote control
If you want to add a function to the SRU 7040, you can contact the
Philips service line for Universal Remote Control to ask for the 5-figure code
for the extra function.
Assigning the volume control to another mode
The volume controls (Vol +,Vol - and s) on the SRU 7040 are assigned to
either your TV or your amplifier/receiver, depending on the device you have
selected:
10
Instructions for use
English