Briggs & Stratton 020212-0 - Manual (Page 7)

7
2. Insert carriage bolts through holes from outside of the
unit and attach a plastic knob from inside of unit
(Figure 2).Tighten by hand.
3. Insert one “L” hook through hole just under billboard
on left side of handle (viewing from rear of unit). Hold
hook in place and attach a plastic knob from inside of
unit (Figure 3).Tighten by hand.
4. Insert other “L” hook through hole just above
billboard on right side of handle (viewing from rear of
unit). Hold hook in place and attach a plastic knob
from inside of unit (Figure 3).Tighten by hand.
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
• Refer to engine owner’s manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer to
engine owner’s manual for recommendations.
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
1. Uncoil high pressure hose and attach one end of hose
to base of spray gun (Figure 4).Tighten by hand.
CAUTION
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
Figure 4 — Connect High Pressure Hose to Spray Gun
Hose Hook
Spray Gun
Hook
Figure 3 — Attach “L” Hooks to Handle
SpeedClean™ 2800 PSI Pressure Washer
Figure 2 — Secure Handle