beautypg.com

Cleaning and applying chemical, Caution, Low pressure high pressure – Briggs & Stratton 020212-0 User Manual

Page 11

background image

11

4.

Pull back on collar, insert new spray tip and release
collar.Tug on spray tip to make sure it is securely in
place.

5.

For most effective cleaning, keep spray tip from 8 to
24 inches away from cleaning surface. If you get spray
tip too close, you may damage cleaning surface.

6.

DO NOT get closer than 6 inches when cleaning tires.

Cleaning and Applying Chemical

IMPORTANT: Use soaps designed specifically for
pressure washers.
Household detergents could damage
the pump.

To apply detergent follow these steps:

1.

Review the use of spray tips.

2.

Prepare detergent solution as required by
manufacturer.

3.

Place chemical injection siphon/filter into detergent
container.

4.

Make sure black spray tip is installed.

NOTE: Detergent cannot be applied with the high
pressure spray tips (White,Yellow, or Red).

5.

Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray
gun and pump and start engine.

6.

Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.

7.

Allow detergent to soak in between 3–5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow detergent
to dry on (prevents streaking).

IMPORTANT: You must flush the chemical injection
system after each use by placing the filter into a bucket of
clean water, then run the pressure washer in low pressure
for 1-2 minutes.

CAUTION

• Starting the engine without all the hoses connected and

without the water turned ON will damage the pump.

• Damage to equipment resulting from failure to follow this

instruction will void warranty.

You must attach all hoses before you start the engine.

CAUTION

• When inserting the filter into a detergent solution bottle,

route the tube so as to keep it from inadvertently contacting
the hot muffler.

Keep the chemical injection tube from coming in contact
with the hot muffler.

40° White

15° Yellow

0° Red

Black

Use to apply

chemical

Figure 11 — Spray Tip Spray Patterns

Low Pressure

High Pressure

SpeedClean™ 2800 PSI Pressure Washer