Jump-starting – BMW 2004 Mini Convertible Cooper User Manual

Page 136

134

JUMP-STARTING

When your battery is discharged, you can
use two jumper cables to start your vehicle
with power from the battery in a second
vehicle. Correspondingly you can help start
another vehicle. Only use jumper cables
with fully insulated handles on the termi-
nal clamps.

Preparing for jump-starting

Do not touch live wiring and cables
on a running engine. There is a risk of

fatal injury if you do this. Carefully observe
the following instructions to avoid per-
sonal injury and/or damage to either vehi-
cle or both vehicles. Make sure that there is
no contact between the bodywork of the
two vehicles to avoid a short circuit haz-
ard.

1. Check whether the battery of the sup-

port vehicle has 12 Volts and approxi-
mately the same capacity measured in
Ah. These data are printed on the bat-
tery

2. Switch off the engine of the support

vehicle

3. Switch off any electrical systems and

components in both vehicles.

Connect the jumper cables

Always adhere to this sequence when
connecting the jumper cables; failure

to observe this procedure can lead to spark-
ing and pose an injury hazard.

The illustration shows the auxiliary jump-
starting terminal on the MINI COOPER S
and the MINI COOPER S Convertible. In the
MINI COOPER S and the MINI COOPER S
Convertible, the auxiliary jump-starting
terminal, arrow 1, acts as the positive bat-
tery terminal, refer to view of engine com-
partment on page

107

. The cover is marked

with a +.
1. Remove the cover of the battery or open

the cover of the auxiliary jump-starting
terminal:
>MINI COOPER and MINI COOPER Con-

vertible:
Remove the battery cover.
To do so, press the two clips simulta-
neously.