BMW 2004 Mini Convertible Cooper User Manual

Page 132

130

MINI MOBILITY SYSTEM

Pumping in liquid sealant

1. Shake the filling canister
2. Screw the filling hose onto the filling

canister

3. Unscrew the dust protection cap from

the valve of the defective tire

4. Screw out the valve core with the valve

remover. The valve remover is located in
a package with the filling hose.

Place the valve core and valve
remover only on clean surfaces.

5. Remove the cap from the filling hose
6. Push the filling hose onto the tire valve

7. Hold the filling canister with the cap

down and squeeze.
Squeeze the entire contents of the canis-
ter into the tire

8. Remove filling hose
9. Screw valve core into the tire valve with

the valve remover.

In the event of a lost or dirty valve
core you will find another valve core

in a package with the filling hose.
Please remember that the liquid canister
must be replaced every four years if the
equipment has not been used.

Reinflating the tire

1. Screw hose 1 with manometer onto the

tire valve

2. Connect plug 3 to the cigarette lighter

socket in the vehicle interior, refer to
page

3. Ignition key in position 1:

Turn on compressor 2

4. Inflate the tires to at least 26 psi /

180 kPa, but not to more than 36 psi /
250 kPa.
To check the current air pressure, shut
off the device for a short time.

Do not run the compressor for
longer than 6 minutes, otherwise

the device will overheat and possibly be
damaged.