Black & Decker 90510288 - Manual (Page 6)

6
X
When cutting thin sheet metal, clamp a piece of scrap
wood to the back surface of the workpiece and cut through
this sandwich.
X
When cutting metal piping, do not cut directly through the
pipe as you would saw a wooden dowel. Instead, cut
around the circumference of the pipe to avoid pinching the
blade. Only one section of the blade should be in contact
with the pipe.
X
Spread a film of oil along the intended line of cut.
Maintenance
Your Black & Decker tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.
Warning! Before performing any maintenance on the tool,
unplug the charger before cleaning it.
X
Regularly clean the ventilation slots in your tool and
charger using a soft brush or dry cloth.
X
Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner. Never let
any liquid get inside the tool and never immerse any part of
the tool into liquid.
Protecting the environment
Should you find one day that your appliance needs
replacement, or if it is of no further use to you,
think of the protection of the environment. Black &
Decker repair agents will accept old Black &
Decker tools and ensure that they are disposed of
in an environmentally safe way.
Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environmental pollution and reduces the
demand for raw materials.
Local regulations may provide for separate collection of
electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
Black & Decker provides a facility for the collection and
recycling of Black & Decker products once they have reached
the end of their working life. To take advantage of this
service please return your product to any authorised repair
agent who will collect them on our behalf.
You can check the location of your nearest authorised repair
agent by contacting your local Black & Decker office at the
address indicated in this manual. Alternatively, a list of
authorised Black & Decker repair agents and full details of
our after-sales service and contacts are available on the
Internet at: www.2helpU.com.
Batteries
Black & Decker batteries can be recharged many
times. At the end of their useful life, discard
batteries with due care for our environment:
Run the battery down completely, then remove it from the
tool.
NiCd and NiMH batteries are recyclable. Take them to any
authorised repair agent or a local recycling station.
Technical data
EC declaration of conformity
CHS6000
Black & Decker declares that these products conform to:
Standards & Legislation.
98/37/EC, 89/336/EEC, 73/23/EC, EN60745, EN60335,
EN55014, EN50336
LpA (sound pressure) 70.1 dB(A),
LWA (acoustic power) 80.1 dB(A),
hand/arm weighted vibration 1.4 m/s2
KpA (sound pressure uncertainty) 3 dB(A),
KWA (acoustic power uncertainty) 3 dB(A)
Kevin Hewitt
Director of Consumer Engineering
Spennymoor, County Durham
DL16 6JG,
United Kingdom
31-09-2006
CHS6000
Voltage Vdc 6
No-load speed min-1 1850
Stroke length mm 13
Max. Depth of cut
Wood
mm 25
Steel mm 2
Plastic pipe mm Ø 12
Weight kg 0.825
Charger
Input voltage
Vac 230
Approx. charging time h 6-8
Weight kg 0.19