Bunn Autopod Brewer 411701 - Manual (Page 8)

Page 8
FACTORY DEFAULTS
NO YES
AutoPOD BREWER
VERSION xx.xx
TEST SWITCHES allows testing of the membrane switches.
TEST SWITCHES ?
NO YES
AIR PUMP
Activates the air pump motor for the brew tank.
AIR PUMP
ON NEXT OFF
WATER INLET
Activates the water inlet valve for the brew tank, and fl ow meter count.
WaterInIet #
ON NEXT OFF
HOT WATER
Activates the water inlet solenoid for the hot water tank.
HOT WATER
ON NEXT OFF
VENT VALVE
Activates the vent solenoid for the hot water tank.
VENT VALVE
ON NEXT OFF
WATER PUMP
N/A
WATER PUMP
ON NEXT OFF
HOT WATER AIR PUMP
Activates the air pump motor for the hot water tank.
HotWaterAir PUMP
ON NEXT OFF
TANK HEATER
Activates the triac/relay on the main control board for the brew tank heater.
TANK HEATER
ON NEXT OFF
WITC
Press the hidden program switch to go back to previous screen. Pressing any
other membrane switch will give corresponding readout for that switch.
FACTORY DEFAULTS
Reset all brew settings, calibrations back to factory presets.
Requires following "INITIAL SETUP" procedure.
EXIT PROGRAM MODE TO MAIN SCREEN
Model:
Software version:
411701 061308
FACTORY BLOWOUT
NO YES
FACTORY BLOWOUT
Used for tank draining.
FACT
FACT
Auto
PROGRAM SWITCH
TO EXIT
CH M SW