Philips AVENT Vigilabebés DECT - Manual (Page 13)

13
7.8 Temperature alert on/off
D Note:
You can only switch the temperature alert on and
off in the menu of the parent unit.
D Note:
If the temperature alert is activated too often,
reduce the set minimum temperature and/or
increase the set maximum temperature (see
‘Setting room temperature range’).
If the temperature alert is switched on, the
parent unit beeps if the actual room temperature
exceeds the set maximum temperature or drops
below the set minimum temperature. In addition,
the backlight of the parent unit display goes on
and ‘high’ or ‘Low’ appears on the display. If no
minimum and maximum temperatures have been
set, the temperature alert is given when the room
temperature drops below 14°C or rises above
35°C.
1
Select ‘Temperature’ with the + and - buttons.
2
Press the OK button to confirm.
3
Select ‘Alert’ with the + and - buttons.
4
Press the OK button to confirm.
5
If the alert is off, the display shows ‘On?’. Press
the OK button to switch on the alert. If the
alert is on, the display shows ‘Off?’. Press the
OK button to switch off the alert.
7.9 Setting temperature scale
D Note:
You can only set the temperature scale in the
menu of the parent unit.
You can set the temperature scale either to
Celsius (C) or Fahrenheit (F).
1
Select ‘Settings’ with the + and - buttons.
2
Press the OK button to confirm.
3
Select ‘Temp scale’ with the + and - buttons.
4
Press the OK button to confirm.
5
Select ‘Celsius’ or ‘Fahrenheit’ with the +
and - buttons.
7.7 Setting room temperature
range
D Note:
You can only adjust the temperature range in the
menu of the parent unit.
A baby will sleep comfortably in a room heated
to a temperature between 16°C and 20°C. This is
important, since a baby cannot regulate its body
temperature as well as an adult. A baby needs
more time to adjust to temperature changes.
If you do not set a temperature range, the baby
monitor alerts you when the temperature in your
baby’s room drops below 14°C or rises above
35°C. In this case, the backlight of the parent unit
display goes on and ‘high’ or ‘Low’ appears on
the display. To change the default minimum and
maximum temperature, follow the instructions
below.
D Note:
The temperature of the baby’s room is shown
on the display of the parent unit when they are
linked.
1
Select ‘Temperature’ with the + and - buttons.
2
Press the OK button to confirm.
3
Select ‘Range’ with the + and - buttons.
4
Press the OK button to confirm.
5
Set the desired minimum temperature with
the + and - buttons.
6
Press the OK button to confirm.
7
Set the desired maximum temperature with
the + and - buttons.
8
Press the OK button to confirm.
• The message ‘Saved’ appears on the display.
ENGLIS
h