Switching on/off, Attaching the control panel – Blaupunkt 7 647 482 310 User Manual
Page 8
31
EN
GLISH
The device switches off.
All the current settings are saved.
Any CD already inserted in the device re-
mains there.
Attaching the control panel
Push the control panel into the guides
of the device from the left to the right.
Carefully push on the left side of the
control panel until it clicks into place.
Note:
When attaching the control panel, make
sure you do not push on the display.
If the device was still switched on when you
detached the control panel, it will automati-
cally switch on with the last setting activat-
ed (radio, CD, CD changer or AUX) when
the panel is replaced.
u
u
Switching on/off
There are various ways of switching the de-
vice on/off:
Switching on/off using the vehicle
ignition
The device will switch on/off simultaneous-
ly with the ignition if the device is correctly
connected to the vehicle’s ignition and you
did not switch the device off by pressing
button
2.
Switching on/off using button
2
To switch on the device, press button
2.
To switch off the device, press and
hold down button
2 for longer than
two seconds.
The device switches off.
Note:
To protect the vehicle battery, the de-
vice will switch off automatically after
one hour if the ignition is off.
Switching on with CD draw-in
If the device is switched off and no CD is in
the drive,
gently insert the CD with its printed
side uppermost into the drive
4 until
you feel some resistance.
The drive draws in the CD automatically.
You must not hinder or assist the drive as it
draws in the CD.
The device switches on and CD playback
starts.
u
u
u
Detachable control panel
Switching on/off
02MadeiraPortoCD27_gb.indd 31
02MadeiraPortoCD27_gb.indd 31
26.10.2006 16:08:39 Uhr
26.10.2006 16:08:39 Uhr