Beltronics STi DRIVER - Manual (Page 14)

Troubleshooting
24
Problem
STi beeps briefly at the same
location every day, but no radar
source is in sight.
STi does not seem sensitive to radar
or laser.
STi did not alert when a police car
was in view.
STi did not provide a Safety signal
while within range of an emergency
vehicle.
STi’s display is not working.
STi’s audible alerts are less loud after
the first few alerts.
STi bounces or sags on windshield.
STi’s power-on sequence reoccurs
while you are driving.
Your 14-year old son has changed all
9 of the Programming options.
Solution
• An X-band motion sensor or intrusion alarm is located within
range of your route. With time, you will learn predictable
patterns of these signals.
• Make sure that windshield wipers do not block ST i’s radar
antenna and that the laser lens is not behind tinted areas.
• Determine if your vehicle has an Instaclear
® , ElectriClear ® or
solar reflective windshield which may deflect radar or laser
signals.
• STi may be in City Mode.
• VASCAR (Visual Average Speed Computer and Recorder) a
stopwatch method of speed detection, may be in use.
• Officer may not have radar or laser unit turned on.
• Safety transmitters may not be commonly used in your area.
• Press the SENS button to deactivate Dark Mode.
• STi is in AutoMute Mode. See page 8 for details.
• STi is not making contact with the windshield to provide
stability. While holding down STi’s QuickMount button, slide
STi toward the windshield so that the back top edge makes
firm contact.
• A loose power connection or dirty lighter socket can cause
STi to be briefly disconnected.
• You can return all of the programming options to the factory
defaults by holding down the VOLUME/MUTE and SENS
buttons while you turn the STi on.
25
Problem
STi will not turn on.
STi feels very warm.
Solution
• Check the PWR is on.
• Check that vehicle ignition is ON.
• Check that vehicle lighter socket is functional.
• Try
STi in another vehicle.
• It is normal for STi to feel warm.
Explanation of Displays
No display STi is in the Dark mode (page 9, 16)
PilotHWY One of the many programming messages (pages 12-16)
WorkZone One of the many Safety Radar messages (pages 22-23)
Caution STi has detected a Safety Radar Signal, but the signal isn’t yet strong
enough to decode the specific safety message (page 22-23)
Self Cal STi is running a self-calibration test
Service STi has failed the calibration test. Contact Beltronics for repair
Required
STi Manual 3/28/05 3:39 PM Page 27