Philips AVENT Vigilabebés DECT - Manual (Page 8)

Make sure your hands and the unit are dry when you insert the batteries.
1 Turn the battery compartment lid to the left ( Á OPEN) with the palm of your hand. (Fig. )
Remove the lid.
Insert four 1.5V R6 AA batteries (Fig. ).
Place two batteries on top of each other and make sure the + and – poles of the batteries
point in the right direction.
Put the battery compartment lid back onto the unit and turn it to the right (CLOSE ª) with
the palm of your hand to close it. (Fig. 5)
Note:When the batteries are running low, the battery symbol appears on the display.
parent unit
Battery operation
The parent unit runs on two rechargeable 1.2V AAA NiMh batteries that are supplied with the
appliance.
Make sure your hands and the unit are dry when you insert the batteries.
1 Slide the battery compartment lid downwards to remove it (Fig. 6).
Insert the two rechargeable batteries (Fig. 7).
Make sure the + and – poles of the batteries point in the right direction.
Slide the battery compartment lid back onto the back of the parent unit until it locks into
position (‘click’) (Fig. 8).
Put the adapter in a wall socket and place the parent unit in the charger (Fig. 9).
The POWER light on the charger lights up.
5 Leave the parent unit in the charger until the batteries are fully charged
When charging for the first time or after a long period of disuse: switch off the
parent unit and let it charge continuously for at least 10 hours.
Charging normally takes 8 hours, but it takes longer when the parent unit is switched on
while charging. To keep the charging time as short as possible, switch off the parent unit
during charging.
The POWER light on the charger stays on, even when the batteries are fully charged.
When the batteries are fully charged, the parent unit can be used cordlessly for at least
hours.
Note: The operating time of 24 hours is based on the assumption that the baby unit transmits 25% of
the time and is in standby mode for the rest of the time (when the baby does not make any sound).
Note: When the parent unit batteries are charged for the first time, the operating time is less than 24
hours. The batteries only reach their full capacity after you have charged and discharged them four times.
Note: When the battery symbol on the display is empty and the parent unit beeps, the batteries are
running low. Place the parent unit in the charger.
Note: When the parent unit is not in the charger, the batteries gradually discharge, even when the parent
unit is switched off.
mains operation
1 Make sure you have inserted the rechargeable batteries in the parent unit.
Put the adapter of the charger in the wall socket and place the parent unit in the
charger (Fig. 9).
,
,
,
,
,
,
,
EngliSh 8