Philips AVENT Vigilabebés DECT User Manual
Page 15

Question
Answer
Why does the LINK light
on the parent unit flash
red and why is the
message (
O
) shown
on the display?
The baby unit and the parent unit are out of range of each other.
Move the parent unit closer to the baby unit.
Why does the LINK light
on the parent unit flash
red?
The batteries of the baby unit are running low. Replace the batteries
or connect the baby unit to the mains (see chapter ‘Preparing for
use’).
Why does the parent unit
beep?
If the parent unit beeps while the LINK light flashes red and the
message ( O) is shown on the display, the connection
with the baby unit is lost. Move the parent unit closer to the baby
unit.
If the parent unit beeps and the battery symbol on the display is
empty, the batteries are running low. Recharge the batteries.
If you have switched off the volume while the sound alert is on, the
parent unit beeps whenever the fifth sound level light lights up blue
because the baby unit has picked up a sound.
If you have set the room temperature on the parent unit and the
temperature alert is on, the parent unit beeps when the temperature
drops below the set level or below 7°C or when the temperature
rises above the set level or above 33°C.
Why does the appliance
produce a high-pitched
noise?
The units may be too close to each other. Make sure the parent unit
and the baby unit are at least 1 metre/3 feet away from each other.
The volume of the parent unit may be set too high. Decrease the
volume of the parent unit.
Why don’t I hear a sound/
Why can’t I hear my baby
cry?
The volume of the parent unit may be set too low or may be
switched off. Increase the volume of the parent unit.
The microphone sensitivity level of the baby unit may be set too low.
Set the microphone sensitivity level to a higher level in the menu of
the parent unit.
The baby unit and the parent unit may be out of range of each other.
Reduce the distance between the units.
Why does the parent unit
react too quickly to other
sounds?
The baby unit also picks up other sounds than those of your
baby. Move the baby unit closer to the baby (but observe the
minimum distance of 1 metre/3 feet).
The microphone sensitivity level of the baby unit may be set too high.
Decrease the microphone sensitivity level in the menu of the parent
unit.
Why does the parent unit
react slowly to the baby’s
crying?
The microphone sensitivity level of the baby unit may be set too low.
Increase the microphone sensitivity level of in the menu of the parent
unit.
EngliSh
15