Behringer Ultra-Compact 15-watt Keyboard Amplifier with VTC-Technology and Original 8: Bugera Speaker Ultratone KT108 - Manual (Page 6)

6 ULTRATONE KT108 User Manual
(4) The LOW control allows you to boost or cut the low-frequency range.
(5) With the MID control you can boost or cut the mid-range frequencies.
(6) The HIGH control adjusts the high-frequency range.
◊ With all the settings the following applies: Adjusting the tone
settings on your KT108 lets you refine the sound of your keyboard;
for example, you can add more depth to a bass sound, or you can
bring out the strings upfront by increasing the mids. Sometimes more
neutral settings are desired in order to preserve the character of the
original sound.
(7) The HEADPHONES jack is for headphones. When you plug in your
headphones, the built-in loudspeaker is muted.
◊ The headphone signal can also be routed to a mixing console or
sound reinforcement system. Connect the headphones output on
your KT108 to the line input (LINE IN) on the console (for example,
BEHRINGER EURORACK UB1222FX-PRO). Please use a mono cable for
this application.
◊ Some headphones produce distortion if the volume level is too high.
Please cut back the volume control until the distortion disappears.
(8) Use the POWER switch to switch on your KT108. The POWER switch should
be set to “Off” before you connect your keyboard amp to the mains.
◊ Please note: The POWER switch does not disconnect the unit from the
mains. Unplug the power cord when you don’t want to use the unit
for some time.
(9) SERIAL NUMBER.
(9)
Fig.: 3.2 Rear panel: serial number
4. Audio Connections
All of your amp’s inputs and outputs are laid out as 1/4" connectors. More information
about the connectors can be found in chapter 5. “Specifications.”
◊ Please keep in mind that all the equipment has to be grounded at all
times. For your own protection, never change or disable the grounding
on your equipment or on the cables! The unit shall always be connected
to the mains socket outlet with a protective earthing connection.
strain relief clamp
sleeve
tip
sleeve
(ground/shield)
Unbalanced ¼" TS connector
tip
(signal)
Fig. 4.1: 1/4" TS plug for the INSTRUMENT INPUT (mono)
strain relief clamp
sleeve
ring
tip
sleeve
ground/shield
¼" TRS headphones connector
ring
right signal
tip
left signal
Fig. 4.2: 1/4" TRS plug for headphones and CD input
R
L
R
L
ring
tip
sleeve
tip
tip
sleeve
sleeve
Fig. 4.3: Stereo adapter cable
sleeve sleeve
tip tip
Fig. 4.4: Mono adapter cable