Philips fotodepiladora - Manual (Page 14)

Press the safety ring fully onto the skin with slight pressure.
Note: The safety ring has contact switches that together are the safety system
of the appliance. This safety ring prevents unintentional flashing without skin
contact.
When all contact switches of the safety ring have been pushed
into the appliance, the ‘ready to flash’ light on the back of the
appliance goes on. This may take a few seconds. When the ‘ready to
flash’ light is on, the appliance is ready to release a flash.
Tip: For easier use, stretch the skin you want to treat. On areas with softer skin,
you may need to exert more pressure on the appliance to push in all contact
switches.
5 Press the flash button to release a flash. After the appliance has
flashed once, release the flash button.
6 For the next flash, repeat steps 3, 4 and 5. This can take a few
seconds.
Never flash the same area twice without lifting the appliance off the skin.
This prevents excessive heating and possible burning of the skin.
7 To avoid untreated areas, always make sure there is some overlap
with the previously treated area when you place the appliance on the
skin.The effective light only comes out of the light exit window. Make
sure the flashes are produced close to each other.
Switch off the appliance after you have finished the treatment.
Note: Avoid looking straight into the light coming out of the window when the
appliance is switched on.
Note: The visible light produced by the appliance is the reflection of the flash
on the skin and is harmless to your eyes. It is not necessary to wear goggles
during use.
guidelines for treatment
Recommended number of flashes and treatment time
Area Approx. number of flashes Approx. treatment time
Underarms 25 per underarm 3 minutes per underarm
Bikini line 25 per side 3 minutes per side
Entire bikini area 90 for entire area 10 minutes
One lower leg 160-190 15 minutes
,
EngliSh
1