Philips Elegante microcadena - Manual (Page 11)

10 EN
Insert the red/blue wires to “ • +”,
black wires to “ -”.
3
Release the socket fl ap.
Connect power
Caution
Risk of product damage! Ensure that the power supply •
voltage corresponds to the voltage printed on the back
or the underside of the apparatus.
Risk of electric shock! When you unplug the AC power
•
cord, always pull the plug from the socket. Never pull
the cord.
Before connecting the AC power cord, ensure you
•
have completed all other connections.
1
Connect the power adapter to
the • DC IN jack on the rear of the
main unit
the power socket.
•
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from heat, •
sunshine or fi re. Never discard batteries in fi re.
For fi rst-time use:
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one CR2025 battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Note
Before pressing any function button on the remote •
control, fi rst select the correct source with the remote
control instead of the main unit.
If you are not going to use the remote control for a
•
long time, remove the battery.
Set clock
1
In standby mode, press DISPLAY/
CLOCK to activate the clock setting
mode.
The hour digits are displayed and begin
»
to blink.
Note
In Eco Power Standby mode, press • CLOCK to show
clock fi rst, then press and hold CLOCK to proceed
clock setting.
2
Press repeatedly to select 12 hour or
24 hour format.
3
Press VOL +/- to set the hour.
4
Press DISPLAY/CLOCK to confi rm.
The minute digits are displayed and
»
begin to blink.
5
Press VOL +/- to set the minute.