BenQ PE8700 - Manual (Page 15)

4. Basic Operation
BenQ PE8700 User’s Manual
15
4. Basic Operation
Turning the Power on
Zoom/Focusing
■ The Power LED shines orange when power is
applied and the power switch is in the on position.
■ Press and hold the ON key on the remote control
or the STANDBY/ON key on the projector for
ONE second to turn the projector on. The
POWER LED will flash orange while warming up,
then show a steady green.
■ " Searching…." will be displayed on the screen
before the projector identifies the input signal. This
message will remain on the screen until a valid
signal is detected.
■ If the horizontal frequency of the input signal
exceeds the range of the projector (XGA), a
message reading " Not supportive timing " will be
displayed on the screen. This message will remain
on-screen until you change the input signal.
■ Adjust the projected image size you need with the
zoom ring on the lens. To focus the image, rotate the
focus ring on the lens.
Focus
Zoom in Zoom out