Philips hue Personal Wireless Lighting Luz indirecta - Manual

1
B
Distributor
10275 W. Higgins Road
Rosemont, IL 60018, USA
4404.016.94271
Last update: 06/28/13
LivingColors / LightStrips
0-14
01 02 03 05 04
Light
E N G L I S H SAFETY INSTRUCTIONS - PART B
• The manufacturer advises the correct use of Luminaires (lighting fixtures)! Therefore
always follow these instructions to ensure correct and safe installation and functioning
of the luminaire and keep it for future reference.
• Turn off electrical power at main fuse or circuit breaker box before commencing installation,
maintenance or repair.
• If in doubt, consult a quali ed electrician or contact your retail outlet. Ensure that you
always install the luminiare to the local electrical code. Certain regulations indicate that
luminaires should be installed by a quali ed electrician.
• Observe the correct color of the wiring before installation: white or white tracer (Neutral),
black or black tracer (Line), green or bare copper wire (Ground) and green tracer for
bonding purpose.
• Do not connect this luminaire to a non-grounded electrical system. WARNING: Installing
this xture in a non-grounded electrical system could allow metal parts of the luminaire
to carry electrical current if any wires or wire connections become broken or loose.
Under this condition, anyone coming in contact with the luminaire is subject to electric
shock which could cause injury or death.
• Always use wire nuts/connectors rated for the correct gauge and number of wires used.
CAUTION: Be certain that no bare wire strands are exposed outside of the wire nuts/
connections (if applicable).
• Be careful not to damage or cut the wire insulation (covering) during installation. Do not
permit wires to contact any sharp edges.
• Do not remove thermal insulation pad(s). Doing so will result in increased temperatures
and possible risk of re.
• Maintain interior lighting with a dry cloth duster, do not use abrasives or solvents. Avoid
liquid on all electrical parts.
• Always consider all the technical speci cations of the luminaire. Verify the stated icons on
the identi cation label on the luminaire and the icons that are shown in part A of your
safety instructions.
ATTENTION: Below you will find all the explanations with numeric reference to the
icons respectively in front of these PART-B safety instructions. Applicable icons to your
fixture are shown in PART-A safety instructions.
01- This luminaire should only be installed indoors.
02- Only suitable for dry locations.
03- This product is not suitable for children under 14 years.
04- Suitable for under-cabinet mounting.
05- Philips LivingColors/LightStrips is based on ZigBee LightLink, an open standard for
wireless communication within the home. All Philips ZigBee LightLink Certified products
can be connected with other Philips ZigBee LightLink Certified products.
The Luminaire – as well as all other products from the collection – is designed and tested
in accordance with the strictest national safety standards. In case of construction faults
or material damages, the manufacturer gives a guarantee up to 2 year (unless otherwise
stated on the packaging). Light bulbs and batteries do not fall under the guarantee terms.
Most ballasts, transformers, electronic drivers and emergency battery packs are covered
by separate ballast manufacturer’s warranties, contact Philips for exceptions. Any damage
caused to the luminaire in extreme conditions (coastal areas, industrial surroundings, farm
environments) will not be covered by the guarantee. The period of guarantee starts from
the purchase date and is only valid on presentation of receipt. The guarantee is void if the
luminaire was not installed following the instructions or repaired or modified. The
manufacturer does not accept any liability for damage caused as a result of misuse or
wrong application of the luminaire.
Alterations in design and technical specifications reserved.
© Copyright Philips