Bosch HBN35 - Manual (Page 5)

English 3
Preparation
Before you Begin
Tools and Parts Needed • Phillips head screwdriver
• Measuring tape
• Drill with bit (1/8")
Parts Included • Phillips head screws (6)
27” Appliances
General Information
Power Requirements The outlet must be properly grounded in accordance with all applicable codes.
Dimensions for 27” Wall-Mounted Units
25 1/2"
(648mm)
28 1/4"
(718mm)
27 "
(686mm)
24 13/16"
(630mm)
min. 4 3/4" (121mm)
max. 31 3/8" (797mm)
24 "
(610mm)
23 7/8" (606mm)
22 " (559mm)
29 1/16"
(738mm)
26 3/4"
(680mm)
Single Oven 27”
It is good practice, when oven is
installed at the end of a cabinet run,
adjacent to a perpendicular wall or
cabinet door, to allow at least 1/4”
space between the side of the oven and
the wall/door.
For oven support, install 2x4’s
extending front to back flush with the
bottom and the side of the opening. The
supporting base must be well secured
to the floor/cabinet and level.
Note: The conduit box must be installed
either above or below the unit. If the
conduit box is installed below the unit, a
2” diameter hole or space is required
between the back wall and the right rear
of the 2x4 supports.
The cabinet base must be flat and
capable of supporting a weight of at
least 210 lbs (95 kg).