Important – BT Synergy 3500 User Manual

Page 18

SETTING

Synergy 3500 user guide ~ 3rd Edition ~ 21st October ’02 ~ 4461

To set the day and time

The message counter on the
base unit will flash between
0

and C until the day and time

are set.

The day and time must be set
using the Synergy 3500 handset.

Your Synergy 3500
automatically adds the day
and time to all messages and
memos received.

When you first switch the
power on, the clock is set to
Sunday, 12.01pm

. You can

change the day and time as
required.

Press the

ߜ button twice on

the Synergy 3500 handset.

TAM MENU

will flash on the

display.

Press the 0 button. The prompt
will announce, “To set day and
time press

✱

, to hear day and

time press

”

(Please note that if you press
the

button this will only allow

you to check the day and time.)

Important

The main menu announcements
are automatically announced
through the handset earpiece when

the

ߜ button is pressed twice.

Press the

✱

button. The prompt

will announce, “Please enter
new day and time after the tone”

After the tone enter the day,
followed by the time using the
24 hour clock.

1 = Sun, 2 = Mon,
3 = Tues, 4 = Wed,
5 = Thur, 6 = Fri, 7 = Sat.

For example:

1 1415 = Sunday 2.15pm.

5 0915 = Thursday 9.15am.

You will then hear your setting
confirmed.

Press the

✘

button twice to

return the handset to standby.

Note

If the day and time is entered
incorrectly, the prompt will announce,
“Incorrect, please set again”. Enter
the correct setting within 15 seconds
otherwise the handset will return to
standby mode. If the day and time
is entered incorrectly three times the
handset will return to standby.

Note

If you have any difficulties setting up
your Synergy 3500 please call the
Helpline on

08706 058 047.

enu

crec